top of page
HARBOR COATING SYSTEMS (1)_edited.jpg

SURFACE PREP

Preparation ensures the best surface for our epoxy coating systems.  HCS provides a wide selection of products to ensure the floor is prepared properly and will last for a long term.

crack repair.png
concrete prep photo.png

Crack Repair

Crack Fillers: 100% solids epoxy crack fillers are designed for repairing cracks and defects in concrete or masonry. These products can be used on horizontal and vertical surfaces and offer superior durability.

​

Available Formulations: 

  • Epoxy Crack Filler

  • Novolac Crack Filler

  • Low Modulus Fast Set Gel

  • Underwater Epoxy Paste

  • Underwater Pourable Epoxy

Joint sealant.png

Joint Sealants

Joint Sealants: These products are used to help sustain the health of the floor, by keeping dirt, debris, and water from entering the joint area. HCS has several formulations available for horizontal and vertical applications.

​

Available Formulations: 

  • Flexible Joint Sealant

  • Vertical Joint Sealant

  • Chemical Joint Sealant

  • Fast Set Sealant

  • Novolac Vertical Formulation

dealership flooring.png

Oil Stop Primers

Epoxy Oil Stop Coating:  This product is a two component solvent based epoxy coating that exhibits excellent characteristics for coating over petroleum based oil contaminated concrete substrates.

​

Product Benefits: 

  • Ideal primer for oil contaminated concrete surfaces

  • Good chemical resistance

  • Excellent substrate penetration & adhesion

Joint sealant.png

Epoxy Mortar

Profile/Appearance: approximately 3/16" to 1/4"


Epoxy Mortar is a heavy duty, troweled floor topping that can be used to patch or resurface concrete, metal, and wood floors. These systems are typically used to resurface older, damaged concrete or to protect new concrete in high traffic, abusive industrial facilities. Mortar products offer higher impact resistance and greater compressive strength than concrete. These floor systems are extremely durable, resistant to wear and tear, and can withstand a wide range of chemicals.

​

Special Formulations: 

  • Acid Resistant Formulation

  • Freezer Formulation

  • Arctic Formulation

  • Chemical Resistant Formulation

  • Coal Tar Formulation

  • Cove Base Mortar (for easy cove construction)

Joint sealant.png

Urethane Slurry

Profile/Appearance: 3/16" to 1/8"mils


Urethane Mortar/Slurry systems have good thermal shock capabilities and are a great choice for hot wash down areas. These systems are recommended for resurfacing areas where a durable shock resistant surface is needed. The system also exhibits good freeze/thaw stability and cures down to 45 degrees F. The products are packaged with resin/hardener liquids, aggregate bag, and dry pigment powder additive. Slurry and mortar formulations available.

​

Several options are available to customize these systems including:
DECORATIVE: Decorative appearance achieved with a decorative quartz broadcast
CHEMICAL RESISTANT: utiliizes a novolac epoxy topcoat for added chemical resistance
THERMAL RESISTANT: NP903TC topcoat should be used when good thermal shock capabilities is required

bottom of page